koor - divisie van stemmen
bestaat er een vlotte manier om voor een koor verschillende stemmen op één notenbalk te plaatsen en te behandelen?
een voorbeeld:
- uitgangspunt: ik heb 2 notenbalken voor sopraan, met een verschillende melodie en een verschillende tekst
- ik wil die 2 sopraanstemmen samenvoegen op één notenbalk (divisie)
- daarvoor geef ik de ene stem stem 1 en de andere stem 2
- als ik dan begin toe te voegen op één notenbalk, verdwijnt de tekst van een van de stemmen
kent er iemand een vlotte manier?
groeten,
Tom
Comments
For this English-language forum a translation from https://www.deepl.com/en/translator:
Choir - division of voices
Is there a smooth way to place and handle different voices on one stave for a choir?
an example:
- starting point: i have 2 staves for soprano, with different melody and text
- i want to merge those 2 soprano voices on one stave (division)
- to do this I give one voice voice 1 and the other voice 2
- if I then start adding on one staff, the text of one of the voices disappears
does anyone know a smooth way?
regards,
Tom
In reply to For this English-language… by DanielR
Do you mean have the two voices singing different words at the same time? Adding the text for voice 2 as a second verse might work in some circumstances, perhaps.
It's a bit more complicated if you already have existing notes and lyrics on each stave.
Example:
![Stage_1_original.png]( "Stage_1_original.png")
Stage 1 : the original
Stage 2 : move lyrics for upper stave above the stave
![Stage_2_move_lyrics_above.png]( "Stage_2_move_lyrics_above.png")
Select > More > Same stave > Properties > Show more > Position > Above
or
Select > More > Same stave > (shortcut X)
Stage 3 : swap notes on lower stave to Voice 2
![Stage_3_swap_notes_to_voice_2.png]( "Stage_3_swap_notes_to_voice_2.png")
Select the entire lower stave, then:
Tools > Voices > Exchange Voice 1-2
Stage 4 : implode the lower stave into the upper stave
![Stage_4_implode.png]( "Stage_4_implode.png")
Select the entire content of the upper and lower staves, then:
Tools > Implode
Stage 5 : rename the upper stave, empty (or remove) the unwanted lower stave
![Stage_5_rename_upper_stave_empty_lower_stave.png]( "Stage_5_rename_upper_stave_empty_lower_stave.png")
Stage 6 : correct any wrong layout for Voices 1 and 2 in the combined stave
![Stage_6_reset_layout.png]( "Stage_6_reset_layout.png")
You need to use the Selection Filter to include only Voice 1 and Voice 2.
You must exclude the lyrics, otherwise all the lyrics will end up below the stave!
First: Selection Filter: None, then enable Voice 1 and Voice 2
Then: Ctrl+A (Select all)
Reset layout: Ctrl+R - or Format > Reset shapes and positions
Finally: Selection Filter > All - (reset to default)