Error for engraving clef changes before left and right repeats

• Aug 15, 2023 - 20:02

If there is a clef change in the same measure as a left and right repeat, the new clef will appear in between the two repeats. Ideally, it should appear to the right of the repeats.
Screenshot 2023-08-15 at 12.00.32 PM.png


The solution is to go into properties and set position relative to barline to 'after,' but it would be nice if the program detected such repeats and automatically did this.

Do you still have an unanswered question? Please log in first to post your question.