Repeat Playback with only one volta
I am copying a score with a section ending with an end repeat. There is only one volta for pass 1. Repeat count is two so the repeat starts over a second time. However on the second pass the first volta plays again even though the play list has only 1. Only way to get it to skip is with a second volta which is not possible as this is last measure in the section.
Comments
This is not what I expect, nor can reproduce.
Please share the score
In reply to This is not what I expect,… by jeetee
extracted the section that does not play properly here and in full score. Measure properties and volta properties were defaults.
In reply to extracted the section that… by msokol
Hmm.. it seems you've indeed discovered a new bug. The cause is the combination of the volta with the section end and end repeat somehow.
Given that you do have a section end there though, you can work around the issue by using a D.S. al Fine instead of a first volta without a 2nd one.
In reply to Hmm.. it seems you've indeed… by jeetee
Reported as #320611: single volta end repeat section end
In reply to extracted the section that… by msokol
Volta(s), Repeat lists, and Repeats (:||) should be reset after the section break.
Otherwise, other problems may be occurred.
In reply to I don't think Section-Break… by Ziya Mete Demircan
The previous message from Jeetee is probably correct about it being some bug associated with the end repeat being associated with a section break. Looks like the system is confused. There is not reason to extend into the next section.