Bend tool: notation and layout problems
Nightly d08e14c (4 Jan 2016) on Win 7 HP / MS 2.0.1 on Win 10.
The bend-tool does not notate multi-stage bends properly:
Create the following in the bend tool, then click on OK:
Expected result: Two-level Bend (half-tone up, then another half-tone up, then release) ending on the same level as where it started
Actual result: The second stage is not drawn properly and the end point is below the start level:
And if you create a semitone bend-and-release, the end point is shown below the start point: